China High Quality 37126774041 Suppliers

Forging is a kind of production and manufacturing method in which molten metal materials are poured into the mold cavity, cooled and solidified to obtain commodities. In the automobile industry, many parts are made of pig iron, which accounts for about 10% of the net weight of the vehicle. For example, the cylinder liner, gearbox housing, steering system housing, automobile rear axle housing, brake system drum, various supports and other casting iron parts generally use sand mold.

When installing nitrogen and oxygen sensors, it is essential to protect the electronic control unit from exposure to rain and urea solutions, which may cause detrimental effects.

Tires are like the feet of a large truck, carrying the net weight of the entire body, and are the only small components that the truck touches with the road surface. When describing the intricacy of Tai Chi, there is a saying of "four or two strokes of dry gold", and the small tires can bear more than ten tons or dozens of tons of body weight, which is also the same wonderful! And the tires also rely on the gas filled inside to maintain their support points and cushioning effects. If you're not too meticulous, you can say that a large car is loaded with gas inside the tires! For car enthusiasts, a tire blowout is a big nightmare. I have heard a car enthusiast say that at high speeds, a tire blowout requires 3000 to repair! Therefore, today we will discuss the topic of truck tire pressure with our friends.

​The material of Mercedes-Benz brake discs is ceramic. The brake pads of this material are used because the brake pads of this material have good wear resistance and mechanical strength, as well as their low braking noise. The brake pads are bonded with steel plates and have a heat insulation layer. And the friction block is composed of friction material and adhesive. When braking, it is squeezed on the brake disc or brake drum to generate friction, thereby achieving the purpose of deceleration.

As a major auto consumer, China's auto industry has been the largest in the world for 9 consecutive years, and the auto parts market has been expanding. The release of relevant policies on auto parts will also help to standardize the remanufacturing behavior and market order of auto parts, guarantee the quality of remanufactured products, accelerate the standardized and large-scale development of the remanufacturing industry, and bring broad prospects for the auto parts remanufacturing industry.

There is no specific replacement cycle for Mercedes-Benz brake discs. When the mileage of the vehicle reaches 100,000 kilometers, the brake disc of the vehicle should be checked. If it is damaged or worn to the limit, it should be replaced in time.